A Quick and Dirty Control Panel for the New DCC Turnout Controls.
The old DC NJ International Turnout Machines are being replaced by Tam Valley Depot Singlet DCC Decoder and Servo Drivers. So as a result a new control panel is required for the Fascia Decoders.
Control Panels are way easier to make these days with a computer and printer compared to the old mask and paint method.
This new panel is drawn with the free vector graphics program Inkscape. This time I included labeling for the electrical isolated blocks as well as a letter designation for each of the four city blocks.
The drawing was then printed out and glued to 1/8" Masonite Board. And then drilled to accommodate the Servo Decoders. Done! Easy peasy. Well... except now comes the wiring!
This new auxiliary panel provides a manual way to control the turnouts since primary control of the layout will be controlled by the computer. But I know computers, and my experience with computers has taught me that a manual alternative would be a wise thing. Yes sir! A wise alternative!
Dandy
No comments:
Post a Comment